How to install 2

INTRUCTIONS FOR INSTALLATION AND OPER TION OF 2'' FAUX WOOD BLIND

Thank you for purchasing your blinds. We hope that you will enjoy the quality and value of our products. Prior to installation. plcase read instructions and familiarize yourself with the parts of the blind.

(Figure A)

This package contains:

Blind

Valance and end pieces

2(or more)Valance Clips

2 Mounting Brackets (left,right)

2 hold down brackets

Intermediate Support Brackets

(On blinds 36" wide or greater)

Installation screws

Necessary tools:

Screwdriver

Tape measure

Drill

HOW TO INSTALL THE HORIZONTAL 2'' FAUX WOOD BLIND

1. Attach the 2 inch faux wood venetian blinds Brackets

Installing End Brackets:

Find the end brackets in the bracket pack.

Determine where to position each bracket.

There is a left bracket and a right bracket.

(Figure B & C)

Inside Frame Mounting

For inside mounting, position top of the bracket against inside surface of the window frame.

Diagonally install the two mounting screws.

Make sure end brackets are level.

(Figure D)

Outside Frame Mounting

For outside nounting,place the bracket on the surface of the window molding or wall and attach with fasteners sufficient for the installation.

(Figure E)

Installing 50mm Foam Wood Venetian Blinds Support Brackets

(These are provided for blinds over 36'' wide)

Space brackets evenly along headrail, between end brackets. Position each bracket so that it will not interfere with movement of the working parts inside the headrail. Make sure support brackets are level with the mounting brackets.

(Figure F)

Secure support brackets with two screws to window frame(inside mount) or molding (outside mount).

2. Install Headrail

Note:When using support brackets,you must first cngage the headrail before inserting the blinds into the end brackets.

Lift headrail into position. Insert the headrail into the end brackets. Push headrail all the way back so that the front of the headrail is completely inserted into the brackets. Close the end bracket covers until they snap into place.

To remove the headrail, swing the bracket cover up or the side. (You may use a screwdrivcr tip to push the cover open).

Remove the headrail.

3. Hang the Valance

The plastic valance clips slide into the back of the valance and clip onto the headrail. Attach valance side pieces to outside mount.

If inside mount does not have enough room for valance chp to hook onto headrail, attach valance to headrail with heavy-duly double sided foam tape or Velcro.