How to Shorten The Venetian Blinds ?
Apr 26, 2024
INSTRUCTIONS
1.Accessories Enclosed
A. 1 × Bind
B. 2 × Mounting Brackets
C. 2 × Control/Tilt Wand
D. 2 × Hold down Brackets
E. 1 × pack of Screws for Brackets
2.Location of PVC Venetian Blinds Brackets
This bind may be positioned
A. Lnside the window recess.
B. Outside the window recess.
C. On any overhead surface such as the ceiling or upper inside edge of the window frame.
3.Positioning and Securing the Brackets
1 With the bind fuly opened,hold up to the wall in the position it will hang.
2 If the blind is to hang in a recess,allow at least 5mm clearance on each side of the blind.
3 Ensure that the blind is centred left to right and the headrail is level.
4 Make a clear mark with a pencil( 6mm past each end of the headrail).
5 With the larger holes facing top and bottom,level against the pencil mark you have just made.Screw the bracket to the wall or ceiling.The second bracket should be fixed similarly. Be careful to cnsure it is level with the first 25mm PVC Venetian blinds bracket.
6 Note: Wider blinds have a centre support bracket!
7 With the tilt wand laid on the left hand side place the headrail in the brackets.
4 Operating
1 To lower the blind, pull the lift cord to the left.
This will release the cold lock.Lower the blind as required.
2 Pull the lift cord to the right and release to engage the cord lock.
3 To raise the blind, pull on the lift cord until the blind is at the required height.Extend the lift cord to the right and release to engage the cord lock.
4 To alter the angle of the slats,rotate the tilt wand.
FITTING INSTRUCTION CONTINUED ON REVERSE
5 Shortening Such as 1 Inch PVC Venetian Blinds
A.With the blind fully open,remove the buttons in the lift cord.
B. Remove base rail and surplus slats.
C. Cut off excess ladder cord ensuring about one inch surplus remains.
D. Rr-thread lift cord into base rail and re-tie knot in end of lift cord. Insert surplus ladder cord into base rail and replace button.
6 Hold down Brackets
IF you want to fix the base rail to the window sill attach brackets to window frame or sill on each side of the base rail and secure the pin ends on the brackets in the holes provided in the base rail.
7 Cleaning
These blinds may be cleaned with a damp cloth or mild soap and water solution.
Young children can strangle in the loop of pull cords, chains and tapes,and cords that operate window coverings. They can also wrap cords around their necks. To avoid strangulation and entanglement, keep cords out of reach of children. Move beds,cots and furniture away from window covering cords. Please install Safety Cord Tensioner,which is also supplied within the pack.
“Actual components may vary in detall from those shown.
Read More
English
IPv6 network supported
April 25, 2024
